High K-Mesh wannierization: Not enough bvectors found

Post here questions linked with issue while running the EPW code

Moderator: stiwari

Post Reply
srp_100
Posts: 2
Joined: Mon Jun 10, 2024 8:00 pm
Affiliation: UIUC

High K-Mesh wannierization: Not enough bvectors found

Post by srp_100 »

Hello,

I am trying to run a Wannierization calculation on a 32x32x1 K-point mesh. However, I get an error in the epw.out file that says the following:

Code: Select all

kmesh_get_bvector: Not enough bvectors found
Error: examine the output/error file for details
I see in some W90 forums that the error could be occurring due to the high mesh where the nearest neighbor shells are too close and are near-degenerate. I have tried to fix this my altering the kmesh_tol, but the error just jumps between too many neighbors or too few neighbors. I can't seem to find another solution that works.

Any help or insight would be greatly appreciated. I have also attached 2D.win, epw1.in, and epw1.out. Other files can be provided if needed.

Thank you!
Attachments
epw_files1.tar.gz
(17.83 KiB) Downloaded 204 times

Post Reply