Now I want to use ibte method to output electron and hole mobility in EPW calculation at the same time, but no matter how I modify the parameters, only one value will be output. Is there any solution,please? The versions used are qe 6.7 and epw 5.3.1.
You have to use ‘int_mob = .true.’
However it is not recommanded for computational reasons (more expensive that treating them separately with separate Wannierization).
In addition, it the case of a large bandgap, the intrinsic carrier concentration will be very low to the point that the bisection algorithm might be unstable.
Therefore I would recommand:
Thank you for your reply. During the test, we found that in the SERTA calculation, using int_mob = .true., the carrier mobility of electrons and holes can be obtained at the same time. In the IBTE calculation, using int_mob = .true., the mobility of electrons and holes cannot be obtained at the same time. Are there any other parameters that need to be modified? I am looking forward to your answers. Thank you.
In the IBTE calculation, if int_mob = .true. ncarrier = 1E13, the output file only shows the electron mobility. If int_mob = .true. ncarrier = -1E13, only the hole mobility is displayed. I am looking forward for your answers.